Purple Rain Texas Sage Plant

1. Planting: Plant your Purple Rain Texas Sage in a location with full sun or a minimum of 6 hours of direct sunlight each day. Once you’ve found your location, dig a hole that is 2-3 times the width of the container the plant was shipped in and around the same depth. Remove the container and loosen the roots gently with your fingers. Then place the plant in the hole and backfill the dirt.

If you’re planting in a container, choose a container (with drainage holes) that is 2-3 inches larger than the container that it was shipped in. Place a layer of soil in the bottom of the container and then follow the in-ground planting directions above. Place the plant in an area that receives 6 hours of sun per day.

2. Watering: Immediately after planting your Purple Rain Texas Sage, water deeply. Continue watering as needed until the plant is well established (but allow the soil to dry out between waterings). Once established, you may only water when the soil becomes dry more than 2 inches down.

3. Pruning: Prune in late winter before the shrub starts to flower. Using a hand cutter, trim less than a third of the top growth. The spikier the plant, the more flowers it will produce.

4. Fertilizing: Do not fertilize after planting; this plant prefers poor-quality soil.